进口螺杆泵如何保养

发布时间:2018-04-18

进口螺杆泵如何保养

德国KAYSEN(凯森)泵业有限公司

代理:营派阀门(上海)有限公司


进口螺杆泵如何保养

德国KAYSEN(凯森)进口螺杆泵

1、每日的维护和保养 

1.1在螺杆泵停泵时检查齿轮箱内的油位。若有必要,拆下注油螺塞,加油至油标的中心处为止。 
1.2听听是否有异常噪声与震动。 
1.3在泵运转时检查泵是否有泄漏。 
注意:对于机械 密封,在大多数情况下,由于汽化导致从密封泄液孔处观察不到泄漏,但有时少量而又稳定的泄漏是允许的。 
2、每周检查与保养 
2.1对于已经停止工作一周以上的泵,应打开进、出口阀门,接通电动机电源,点动几次泵。 
2.2检查进、出口管道上的阀门是否可以工作正常。 
3、每季的维护与保养 

3.1检查所有基础上的螺母和压紧装置的螺栓是否松动。 
3.2安装规定每三月把齿轮箱的油更换一次。松开齿轮箱的放泄螺塞,将齿轮油放掉。拧紧放泄螺塞,打开注油螺塞,注入清洁的轻油,清洗齿轮箱。清洗干净后打开放泄螺塞,放掉轻油,拧紧放泄螺塞,从注油螺塞口注入规定的齿轮油至油标中间,拧紧注油螺 
4、每年的维护与保养 
4.1检查联轴器的对中情况。 
4.2对照泵和电机的数值,检查泵的流量、压力和功率的情况。如果有必要,在压力和流量下降很多的情况下,则应对泵进行拆卸检修,更换维修已损坏的部件。当然如果泵的性能仍然令人满意,则无需拆泵维修。 
5、润滑油系统油料更换时间 
5.1轴承每月加入一次3#通用锂基润滑脂。 
5.2齿轮箱新泵累计250小时更齿轮油;连续运转每1000小时,更换一次上述相同的齿轮油。5.3机械密封油:保证停机时油位在检视孔中心,日常视情况补充,每半年更换一次。

1, daily maintenance and maintenance
1.1 Check the oil level in the gearbox when the screw pump is stopped. If necessary, remove the oil plug and fill it up to the center of the oil standard. The
1.2 Listen for unusual noise and vibration. The
1.3 Check the pump for leaks while the pump is running. The
Note: For mechanical seals, in most cases, no leakage is observed from the sealed drain hole due to vaporization, but sometimes small but stable leaks are allowed. The
2, weekly inspection and maintenance
2.1 For pumps that have stopped working for more than one week, the inlet and outlet valves should be opened, the motor power should be turned on, and the pump should be moved several times. The
2.2 Check whether the valves on the inlet and outlet pipes can work normally. The
3. Seasonal maintenance and maintenance
3.1 Check whether all the nuts on the foundation and the bolts of the pressing device are loose. The
3.2 Installation regulations Change the gearbox oil every three months. Loosen the bleed plug of the gear box and let the gear oil drain away. Tighten the bleeder plug, open the priming plug, fill with clean light oil, and clean the gearbox. After cleaning, open the leaking screw plug, let go of light oil, tighten the leaking screw plug, and inject the specified gear oil from the oil injection screw plug into the middle of the oil standard, and tighten the oil injection screw.
4, annual maintenance and maintenance
4.1 Check the alignment of the coupling. The
4.2 Check the flow, pressure and power of the pump against the values of the pump and motor. If necessary, in the event of a significant drop in pressure and flow, the pump should be dismantled and repaired, replacing damaged components. Of course, if the performance of the pump is still satisfactory, there is no need to remove the pump for maintenance. The
5, oil system oil replacement time
5.1 Bearings Add 3# Universal Lithium Grease once a month. The
5.2 Gearbox The new pump accumulates more than 250 hours of gear oil. For every 1000 hours of continuous operation, replace the same gear oil. 5.3 Mechanical seal oil: Ensure that the oil level is at the center of the inspection hole when it is shut down. Daily replenishment will be made depending on the situation and replaced every six months.

 

位于德国SchwäbischGmünd的凯森Kaysen泵业有限公司是的各种流体水泵和隔膜泵制造商。60多年来,凯森以“德国制造”的可靠性和质量达到了高标准。凭借我们全面的产品组合,我们支持世界各地的客户掌握供水,采矿,工业,化工,造纸,电力,食品,制药,污水和海上行业的苛刻抽水任务。作为上述领域创新技术的供应商,我们是液体需要安全,高效和经济运输的合作伙伴。
        德国凯森始终坚持“重质量,讲信誉”为宗旨。产品现各地,并已逐步开发海外市场。公司多次被评为“重合同讲信用”企业,深得用户的信赖和广泛的赞誉。
        The Kaysen Pumps GmbH in SchwäbischGmünd, Germany, is one of the world's leading manufacturers of fluid centrifugal pumps and diaphragm pumps. For more than 60 years, Kaisen has achieved the highest standards of reliability and quality of "Made in Germany". With our comprehensive product portfolio, we support customers around the world to successfully grasp the harsh pumping tasks of water supply, mining, industry, chemical, er, electricity, food, pharmaceutical, sewage and marine industries. As a leading provider of innovative technology in these areas, we are the perfect partner for liquids to be safe, efficient and economical to transport. ,
          Germany Kaysen always adhere to the "quality, stresses credibility" for the purpose. Products are selling all over the country, and has gradually developed overseas markets. The company has repeatedly been rated as "the contract with the letter" business, won the trust of users and extensive praise.

我们的技术团队

Our technical team

上一篇:油泵HSNF1300-42N武...
下一篇:K35D2-40电控换向阀使用说...