LIMM-4/350/V/X12,意大利ATOS阿托斯伺服比例阀
电 话：转8009
手 机；
企业QQ；2880626083
邮箱；@163.com
低工作压差大于 0.04MPa时可选用先导式（压差式）电磁阀
流体清洁度不高时应在电磁阀前安装
过滤器一般电磁阀对介质要求清洁度要好
LIMM-4/350/V/X12,意大利ATOS阿托斯伺服比例阀
两位控制;条件允 许请安装旁路管便于维修有水锤现象时要定制电磁阀的开闭时
高工作压差应 小于电磁阀的大压力
Note flow aperture and tak the caliber sole
When there is water hammersolenoid valve to
General solenoid valves areone-way
working, so to note that ifthere
is anti-pressure, if installed check valve.
customize the opening and closing;
two control; conditions allow, install a bypass pipe, ease of maintenance
一般电磁阀都是单向工作,因此要注 意是否有反压差,如有安装止回阀
注意流量孔径和接管口径电磁阀一般只有开关
Maximumworking pressure should be less than the maximum calibration pressure solenoid valve
LIMM-4/350/V/X12,意大利ATOS阿托斯伺服比例阀
