武汉星兴达液压气动设备有限公司为您提供更多油泵型号，可来电咨询！
A10VSO10DFR/52R-PPA14N00
A10VSO10DFR/52R-PPA14N00-SO858
A10VSO10DFR/52R-PSA14N00-SO858
A10VSO10DFR/52R-PSC64N00
A10VSO10DFR/52R-PUC64N00
A10VSO10DFR/52R-PUC64N00E
A10VSO10DFR/52R-PUC64N00E
A10VSO10DFR/52R-PUC64N00ESO857
A10VSO10DFR/52R-PUC64N00-SO857
A10VSO10DFR/52R-VUC14N00
A10VSO10DFR/52R-VUC14N00-SO420
A10VSO10DFR1/52L-PKC64N00
A10VSO10DFR1/52L-PPA14N00
A10VSO10DFR1/52L-PSC14N00
A10VSO10DFR1/52L-PSC64N00
A10VSO10DFR1/52L-PUC64N00
A10VSO10DFR1/52R-PKC64N00
A10VSO10DFR1/52R-PKC64N00E
A10VSO10DFR1/52R-PKC64N00E
A10VSO10DFR1/52R-PKC64N00-SO857
A10VSO10DFR1/52R-PKC64N00-SO858
A10VSO10DFR1/52R-PPA14N00
其它要求：选用精度比较高的钻床，若钻床主轴径向圆跳动误差较大时，可采用浮动夹头来装夹钻头加工。使用较新或各部分尺寸精度接近公差要求的钻头。因钻头多次使用后会磨损，而影响孔径精度。钻头的两个切削刃需尽量修磨对称，两刃的轴向摆差应控制在.5mm范围内，使两刃负荷均匀，以提高切削稳定性，钻头的径向摆差应小于.3mm。预钻孔应防止产生较多的冷硬层，否则会增加钻削负荷和磨损精孔钻头。钻削中要有充足的冷却润滑液。
