欧洲进口阀门进口高温电磁阀的使用保养
原文：
高温电磁阀的使用保养：
1、建议使用单位派专人负责使用保养。
2、进口高温电磁阀安装后需通入介质实验动作数次，确认正常后方可投入正式使用。
3、应定期清洗大阀内外及衔吸合面的污物，注意不要损坏密封面。
4、高温电磁阀较长时间不用时，应关闭阀前手动阀，重新启用时，进口蒸汽电磁阀应将冷凝水排除干净，并作试动作数次，待开关正常后方可投入使用。
5、进口高温电磁阀从管路上卸下不用时，应将内部及零件拭净并用压缩空气吹净储存。
6、使用时间较长时，如活塞与阀座间密封不好，可将活塞密封面重新磨平，再和阀座研磨。
7、工作时，要注意阀门前后压力表，要求工作压力不得过额定压力，工作压差必须在额定压差范围内。当工作压力过额定压力或工作压差过额定压差时，电磁阀要停止使用，关闭前后手动阀，以免电磁阀爆炸和泄漏。http://www.aocunvalve.com/products/detail/5.html
译文：
High temperature solenoid valves for use and maintenance:
1 recommended by a person responsible for maintenance.
2 high temperature solenoid valve installed after the required access media test action several times known until put into formal use.
3 should regularly clean the valve and the suction surface of dirt in his mouth careful not to damage the sealing surface.
4 a long time when you&re not using high temperature solenoid valve close the valve before the valve manually when you re-enable the steam solenoid valve drain water should be clean and tried a number of times until the normal rear switch can be put into use.
5 high temperature solenoid valve from the pipeline to remove when not in use interior parts and components should be wiping clean with compressed air blowing off store.
6 used for a long time such as bad seal between the piston and valve seat piston sealing surface can be worn again and seat grinding.
7 work should pay attention to before and after the valve pressure gauge required working pressure must not exceed the rated pressure work pressure must be within the rated pressure range. When the pressure exceeds the rated pressure or when the pressure exceeds the rated pressure differential solenoid valve to stop using close the manual valve so as to avoid explosions and the solenoid valve leaking.
进口蒸汽电磁阀‖进口300度蒸汽电磁阀http://www.aocunvalve.com/products/detail/5.html
