进口日本SMC紧凑型气缸安装注意,AN10-01
上海乾拓贸易有限公司
联系人：杨江玲
企业QQ：2880626083
手 机：（微信
电 话：-8012
邮箱；@163.com
地址：上海市嘉定区江桥嘉涌路6号楼713室
特长：
• Switch mounting bracket/Part no.
磁性开关安装后不会露出缸体外，是一种紧凑型气缸。
薄型长方体结构，磁性开关安装可3面或4面位置选择。
• Proper auto switch mounting position (detection at stroke end)
and mounting height • Operating range
带磁性开关(CDQS系列：CDQS、CDQSW、CDQSK、CDQSKW、CDQS□S)
Minimum auto switch mounting stroke
安装注意：
and place a wrench on the portion of the rod that protrudes beyond the section.
Adoption of guide mechanism is strongly recommended for the case
when CQS is used as stopper to prevent non-rotating piston rod from side loads.
When a workpiece is secured to the end of the piston rod,
ensure that the piston rod is retracted entirely,
Also, tighten by giving consideration to prevent the tightening
torque from being applied to the non-rotating guide.
For installation and removal, use an appropriate pair of pliers
a type C retaining ring). Be much careful with the popping of a retaining ring.
Besides, be certain that a retaining ring is placed firmly into
All loads to piston rod must be applied in axial direction only.
When a lateral load is applied unavoidably,
ensure that it should not exceed the allowable lateral load to the rod
(tool for installing a type C retaining ring).
Even if a proper plier (tool for installing type C retaining ring) is used,
it is likely to inflict damage to a human body or peripheral equipment,
as a retaining ring may be flown out of the tip of a plier (tool for installing
end as specified in graph (1) to (5). When installing a cylinder,
centering should be required accurately.
the groove of rod cover before supplying air at the time of installment.
技术参数;
Ambient and fluid temperature Cushion Rod end thread
Stroke length tolerance Mounting Piston speed Allowable leakage
(No freezing) With auto switch: –10 to 60°C (No freezing)
Through-hole/Both ends tapped common
None, Rubber bumper∗ Female thread +1.0 0
12 16 20 25 Pneumatic (Non-lube) Double acting, Single rod Air
1.05 MPa 0.7 MPa Without auto switch: –10 to 70°C
50 to 500 mm/s 0.5l/min (ANR) or less
Type Action Fluid Proof pressure Maximum operating pressure
产品图片：
进口日本SMC紧凑型气缸安装注意,AN10-01
