进口气动隔膜泵KAYSEN

发布时间:2018-04-19

进口气动隔膜泵KAYSEN

德国KAYSEN(凯森)泵业有限公司

代理:营派阀门(上海)有限公司

我们的进口气动隔膜泵来自德国KAYSEN(凯森),我们的进口气动隔膜泵在德国SchwäbischGmünd工厂生产。


德国KAYSEN凯森进口气动隔膜泵概述
气动隔膜泵是目前国内新颖的一种泵类。对于各种腐蚀性液体,带颗粒的液体,高粘度、易挥发、易燃、剧毒的液体,均能予以抽光吸尽。
气动隔膜泵采用压缩空气为动力源,对于各种腐蚀性液体,带颗粒的液体,高粘度、易挥发、易燃、剧毒的液体,均能予以抽光吸尽。
泵体采用四种材质,铝合金、铸铁、工程塑料、不锈钢。根据不同液体介质分别采用丁晴橡胶、氯丁橡胶、氟橡胶、聚四氟乙烯。以满足不同用户的需要。

主要特点:
气动隔膜泵不需灌引水,吸程高达7m,扬程达50m,产品扬程可以达到70米左右,出口压力≥7kgf/cm2; 流动宽敞,通过性能好,允许通过大颗粒直径达10mm。抽送泥浆、杂质时,对泵磨损甚微; 扬程、流量可通过气阀开度实现无级调节(气压调节在1-7kgf/cm2之间); 该气动隔膜泵无旋转部件,没有轴封,隔膜将抽送的介质与泵的运动部件、工作介质完全隔开,所输送的介质不会向外泄漏。所以抽送有毒、易发挥或腐蚀性介质时,不会造成环境污染和危害人身安全; 不必用电,在易燃、易爆场所使用安全可靠; 可以浸没在介质中工作;
使用方便、工作可靠、开停只需简单地打开和关闭气体阀门,即使由于意外情况而长时间无介质运行或突然停机,气动不锈钢隔膜泵也不会因此而损坏,不旦负荷,泵会自动地停机,具有自我保护性能,当负荷恢复正常后,又有自动启动运行; 结构简单、易损件少,该气动不锈钢隔膜泵结构简单,安装、维修方便,泵输送的介质不会接触到配气阀,联杆等运动部件,不象其他类型的泵因转子、活塞、齿轮、叶片等部件的磨损而使性能逐步下降; 可输送较粘的液体(粘度在1万厘泊以下); 本泵无须用油润滑,即使空转,对气动不锈钢隔膜泵也无任何影响
 

主要优点:
使用方便、工作可靠、开停只需简单地打开和关闭气体阀门,即使由于意外情况而长时间无介质运行或突然停机泵也不会因此而损坏,一旦负荷,泵会自动地停机,具有自我保护性能,当负荷恢复正常后,又能自动启动运行
结构简单、易损件少,该泵结构简单,安装、维修方便,泵输送的介质不会接触到配气阀,联杆等运动部件,不像其他类型的泵因转子、活塞、齿轮、叶片等部件的磨损而使性能逐步下降
可输送较粘的液体(粘度在1万厘泊以下)
不需灌引水,吸程高达5米,扬程达70米,出口压力≧7bar
流动宽敞,通过性能好,允许通过大颗粒直径达10毫米。抽送泥浆、杂质时,对泵磨损甚微
本泵无须用油润滑,即使空转,对泵也无任何影响
不必用电,在易燃、易爆场所使用安全可靠
可以浸没在介质中工作
扬程、流量可通过气阀开度实现无级调节(气压调节在1-7bar之间)
该泵无旋转部件,没有轴封,隔膜等抽送的介质与泵的运动部件、工件介质完全隔开,所输送的介质不会向外泄漏。所以抽送有毒、易挥发或腐蚀性介质时,不会造成环境污染和危害人身安全

主要应用:
油井钻好后,用气动隔膜泵吸沉积物及灌浆。
吸各种乳剂和填料。
吸各种污水。
各种强酸、强碱、强腐蚀液体。
吸各种高温液体高可耐150度。
可以吸花生酱、泡菜、土豆泥、小红肠、果酱苹果浆、巧克力等。
矿井、坑道、隧道、选矿、矿渣中的积水。泵吸水泥灌浆及灰浆。
不锈钢隔膜泵泵吸各种橡胶浆。
不锈钢气动隔膜泵可以吸各种磨料、腐蚀剂、石油及泥浆、清洗油垢及一般容器。
可以吸各种剧毒、易燃、易挥发液体。
不锈钢气动隔膜泵可以用于吸油漆、树胶、颜料。
不锈钢气动隔膜泵作为各种固液体分离设备的前级送压装置。
气动隔膜泵可以用于为油轮,驳船清仓吸取仓内污水。
吸啤酒花及发酵粉稀浆、糖浆、糖密。
粘合剂和胶水、全部种类可用泵吸取。
各种瓦、瓷、砖器及陶器釉浆。

进口气动隔膜泵如何保养

德国KAYSEN(凯森)进口气动隔膜泵

我们要确保气动隔膜泵始终处于良好的运行或备用状态,因此所有大厦安装的生活气动隔膜泵,消防泵、喷淋泵、补压泵、排污泵、空调气动隔膜泵,应当由管理处维修人员负责气动隔膜泵定期保养。 

一、生活气动隔膜泵和空调气动隔膜泵每周进行一次日常检查保养,每半年进行一次全面保养。 二、消防气动隔膜泵和喷洒泵每一个月、补压泵每二月进行一次试运行,运行时间10-15分钟,消防泵起动时在管网顶部试消火栓出口喷水射程达6M以上,每半年进行一次全面保养。 

三、排污泵、潜气动隔膜泵每半年进行一次全面保养。 

四、气动隔膜泵保养时应把与泵体相连的2米范围内阀门、压力表、管道等随泵同时保养。 五、泵体的保养 

1、检查泵体应无破损、铭牌完好、水流方向指示明确清晰、外观整洁、油漆完好。 2、补充润滑油,若油质变色,有杂质,应予更换。 

3、检查盘根密封情况,若有漏水应增加或更换石棉绳填料。 4、联轴器的联接螺栓和橡胶垫若有损坏应予更换。 5、紧固机座螺丝并做防锈处理。 

6、生活气气动隔膜泵和空调气动隔膜泵因运转频繁,每年应拆开联轴器两端轴承进行清或更换。 六、电机的保养 

1、外观检查应整洁,铭牌完好,接地线连接良好。 

2、拆开电机接线盒内的导线连接片,用500V兆欧表测试电机绕组相与相、相对地间的绝缘电阻值应不低于0.5兆欧。 

3、电机接线盒内三相导线及连接片应牢固紧密。 七、相关阀门、管道及附件的保养 

1、各个阀门的开关应灵活可靠,内外无渗漏。 2、单向阀动作应灵活,阀体内外无漏水。 3、压力表指示准确,表盘清晰。 

4、管道及各附件外表整洁美观、无裂纹,油漆应完整无脱落。

We must ensure that the pneumatic diaphragm pump is always in good operation or standby state, so all life-installed pneumatic diaphragm pumps, fire pumps, spray pumps, pressure pumps, sewage pumps, and air-conditioning pneumatic diaphragm pumps should be maintained by the management staff. Responsible for regular maintenance of pneumatic diaphragm pumps.
First, the daily life of the pneumatic diaphragm pump and air-conditioning pneumatic diaphragm pump once daily inspection and maintenance, a comprehensive maintenance every six months. 2. Each month of the fire-fighting pneumatic diaphragm pump and spray pump, the compensator pump shall be tested every two months. The running time shall be 10-15 minutes. When the fire pump is started, the water spray range of the fire exit at the top of the pipe network shall exceed 6M. Perform a full maintenance in half a year.
Third, the sewage pump, submersible pneumatic diaphragm pump to conduct a comprehensive maintenance every six months.
Fourth, the maintenance of pneumatic diaphragm pump should be connected with the pump body within 2 meters of valves, pressure gauges, pipes, etc. with the pump maintenance. Fifth, the maintenance of the pump
1. Check that the pump body is not damaged, the nameplate is in good condition, the flow direction is clear and clear, the appearance is clean, and the paint is in good condition. 2, add oil, if oil discoloration, impurities, should be replaced.
3, check the packing seal, if there is leakage, increase or replace asbestos rope packing. 4. The coupling bolts and rubber pads of the coupling should be replaced if damaged. 5. Fasten the seat screw and do anti-rust treatment.
6. Due to the frequent operation of domestic air-pneumatic diaphragm pumps and air-conditioned pneumatic diaphragm pumps, the bearings at both ends of the coupling should be dismantled each year for cleaning or replacement. Six, motor maintenance
1. The appearance inspection should be tidy, the nameplate is in good condition, and the grounding cable is well connected.
2. Disconnect the wire connecting piece in the motor terminal box and test the insulation resistance between the phase and phase of the motor winding with a 500V megohmmeter. The value of the insulation resistance should not be lower than 0.5 megohm.
3. The three-phase conductors and connecting pieces in the motor terminal box should be tight and tight. VII. Maintenance of related valves, pipes and accessories
1. The opening and closing of each valve should be flexible and reliable, with no leakage inside and outside. 2. The check valve should be flexible and there is no leakage inside and outside the valve. 3, pressure gauges are accurate and the dial is clear.
4. The appearance of pipes and accessories is clean and beautiful, no cracks, and the paint should be completely free from falling off.


 

位于德国SchwäbischGmünd的凯森Kaysen泵业有限公司是的各种流体水泵和隔膜泵制造商。60多年来,凯森以“德国制造”的可靠性和质量达到了高标准。凭借我们全面的产品组合,我们支持世界各地的客户掌握供水,采矿,工业,化工,造纸,电力,食品,制药,污水和海上行业的苛刻抽水任务。作为上述领域创新技术的供应商,我们是液体需要安全,高效和经济运输的合作伙伴。
        德国凯森始终坚持“重质量,讲信誉”为宗旨。产品现各地,并已逐步开发海外市场。公司多次被评为“重合同讲信用”企业,深得用户的信赖和广泛的赞誉。
        The Kaysen Pumps GmbH in SchwäbischGmünd, Germany, is one of the world's leading manufacturers of fluid centrifugal pumps and diaphragm pumps. For more than 60 years, Kaisen has achieved the highest standards of reliability and quality of "Made in Germany". With our comprehensive product portfolio, we support customers around the world to successfully grasp the harsh pumping tasks of water supply, mining, industry, chemical, er, electricity, food, pharmaceutical, sewage and marine industries. As a leading provider of innovative technology in these areas, we are the perfect partner for liquids to be safe, efficient and economical to transport. ,
          Germany Kaysen always adhere to the "quality, stresses credibility" for the purpose. Products are selling all over the country, and has gradually developed overseas markets. The company has repeatedly been rated as "the contract with the letter" business, won the trust of users and extensive praise.


上一篇:PHOENIX电缆VIP-CAB...
下一篇:ZW32-40.5/T1600-...