武汉星兴达液压气动设备有限公司为您提供更多油泵型号，可来电咨询！
A10VSO10DFR/52R-PPA14N00
A10VSO10DFR/52R-PPA14N00-SO858
A10VSO10DFR/52R-PSA14N00-SO858
A10VSO10DFR/52R-PSC64N00
A10VSO10DFR/52R-PUC64N00
A10VSO10DFR/52R-PUC64N00E
A10VSO10DFR/52R-PUC64N00E
A10VSO10DFR/52R-PUC64N00ESO857
A10VSO10DFR/52R-PUC64N00-SO857
A10VSO10DFR/52R-VUC14N00
A10VSO10DFR/52R-VUC14N00-SO420
A10VSO10DFR1/52L-PKC64N00
A10VSO10DFR1/52L-PPA14N00
A10VSO10DFR1/52L-PSC14N00
A10VSO10DFR1/52L-PSC64N00
A10VSO10DFR1/52L-PUC64N00
A10VSO10DFR1/52R-PKC64N00
A10VSO10DFR1/52R-PKC64N00E
A10VSO10DFR1/52R-PKC64N00E
A10VSO10DFR1/52R-PKC64N00-SO857
A10VSO10DFR1/52R-PKC64N00-SO858
A10VSO10DFR1/52R-PPA14N00
一般切入3-4圈螺纹时，丝锥位置应正确无误。以后，只须转动绞手，而不应再对丝锥加压力，否则螺纹牙形将被损坏。攻丝时，每扳转绞手1/2-1圈，就应倒转约1/2圈，使切屑碎断后容易排出，并可减少切削刃因粘屑而使丝锥轧住现象。攻不通的螺孔时，要经常退出丝锥，排除孔中的切屑。攻塑性材料的螺孔时，要加润滑冷却液。对于钢料，一般用机油或浓度较大的乳化液要求较高的可用菜油或化钼等。对于不锈钢，可用3号机油或硫化油。
